Experiment: The Neuromuscular Junction Experiment: The Neuromuscular Junction

Experiment: The Neuromuscular Junction

Experiment: The Neuromuscular Junction

image5.jpgEach skeletal muscle is connected to the nervous system be motor end units. When the neurotransmitter acetylcholine is release at this site, the muscle fiber depolarizes. Calcium ions are released from stores in the sarcoplasmic reticulum. The presence of Ca2+ triggers the ratcheting of actin and myosin filaments and the contraction of the myofiber as all of the myofibrils contract simultaneously.

Materials

Neuromuscular Junction Digital Slide Images Neuromuscular Junction (Longitudinal Section) Digital Slide Images

Procedure

1. Examine the digital slide images of the neuromuscular junction.

image1.png
Neuromuscular junction 100X.
image2.png
Neuromuscular Junction (Longitudinal Section) 1000X.

Post-Lab Questions

Permalink: https://collepals.com/experiment-the-n…uscular-junction/ ‎

1. Identify the axon, terminal branches, and muscle fibers in the slide image below. If possible, trace the fiber to its terminus. image3.jpg

2. Are there few or many nuclei at the end plate?

3. What is a motor unit?

4. How is a greater force generated (in terms or motor unit recruitment)?

5. What types of sensors are present within the muscle to identify how much force is generated?

Experiment 3: Muscle Fatigue

Muscle contractions are essential for muscles to function properly. The inability of a muscle to maintain tension is muscle fatigue. Failure to contract may occur because of the accumulation of lactic acid, a lack of ATP, or decreased blood flow. In this exercise, you will investigate the correlation between repeated movements and muscle fatigue.

image6.jpg

Materials

Rubber Band

Stopwatch

Note: If you suffer from a medical condition that does not permit you to perform this activity, please ask a partner to volunteer for you.

Procedure

1. Hypothesize how many times you can stretch a rubber band between your thumb and pinky finger in 20 seconds. Record your predictions in the table below.

2. Using your dominant hand, count the number of times you can completely stretch a rubber band between the thumb and pinky finger in 20 seconds. Be sure to stretch the rubber band as far as possible each time and do not take a break in between trials.

3. Record your count for each trial in Table 1.

Table 1: Experimental Counts
  Trial 1 Trial 2 Trial 3 Trial 4 Trial 5
Predicted Value
Actual Value

Post-Lab Questions

1. How did the predicted results compare to the actual results?

2. Did you notice any changes in the number of repetitions you could perform, or how your hand felt after each of the trials?

3. Explain the actions that were occurring at the cellular level to produce this movement. Include sources of energy and any possible effect of muscle fatigue.

4. Hypothesize what would happen if blood flow was restricted to the hand when this experiment is performed.

Experiment 4: Gross Anatomy of the Muscular System

image7.jpgMuscle actions are often described as a departure of the from the anatomical position of the body. In performing the next exercise, you will understand how muscles act to affect motion.

Materials

*Participant (can be yourself) *Heavy Object (approximately 5 pounds)

*You must provide

Procedure

1. Begin by examining muscles found in the upper limbs. First, extend your forearm so you have a clear view of your hand. What muscle is required to perform this extension? Extend your fingers out so they are straight and splayed apart. Then, retract your fingers into a tight fist. Repeat this motion several times, observing the wrist and hand muscles as the flex and relax. What muscles are used to complete this action? Record your observations in Table 2.

Note: It is helpful to palpate the area being flexed to better identify which muscles are being used.

2. Moving up the limb, extend your forearm out until it is parallel to the ground. Have a partner press down on your forearm. Flex your forearm to provide resistance as your partner pushes down. Observe the forearm and identify which muscles are being used. Record your observations in Table 2.

3. The partner should stop pushing down on your forearm, but keep it extended. Curl the forearm upward, creating a bend at the elbow. Observe which muscles are being used to complete this action, and record your observations in Table 2.

4. Find a heavy object, and pick it up. Keeping your arm straight, raise the object out to the side until it is parallel to the ground. What muscles does this require? Continue holding the object, and extend your arm back behind you. What muscles does this activate? Record your observations in Table 2.

Note: Be sure the heavy object is not too heavy before you lift it. This item should be approximately 5 – 10 pounds. This object should never be raised above your head!

5. Move down to the lower limbs, and determine what motions are needed to view the lower limb muscles in action. For example, you may want to walk, jump, sit, point your toes, etc. Engage at leave seven different muscles and indicate what motion was used to engage each muscle in Table 2.

Table 2: Gross Anatomy Data
Movement Muscle(s) Activated Action(s) of Muscle(s)
1. Forearm Extended (Step 1)
2. Fingers Extended and  Splayed (Step 1)
3. Fingers Retracted (Step 1)
4.  Forearm Pressed Down Upon (Step 2)
5. Elbow Bent (Step 3)
6. Arm Raised to Side with Heavy Object (Step 4)
7. Arm Extended Back with Heavy Object (Step 4)
8. (lower limbs; student selects action…)
9. (lower limbs; student selects action…)
10. (lower limbs; student selects action…)
11. (lower limbs; student selects action…)
12. (lower limbs; student selects action…)
13. (lower limbs; student selects action…)
14. (lower limbs; student selects action…)

Post-Lab Questions

1. Label the human muscle diagram.

image4.jpg

2. Which muscle(s) were used to extend your arm backwards?

3. Which muscle(s) were used to extend and splay your fingers outward?

Experiment 5: ATP and Muscle Fatigue

Muscles require energy to contract. Energy is released when biomolecules such as sugars and fats are broken down, and is stored in the form of ATP. ATP enables muscle contraction, but can only be stored in relatively small amounts. For this reason, the body must continually metabolize new ATP molecules.

image8.jpgMuscle fatigue occurs if the local ATP reservoir for a muscle becomes depleted. This is a common result of strenuous exercise in which ATP is consumed at a faster rate than it is produced. At this point, muscles may fail to contract and the intensity of an exercise must decrease. In this experiment, you will test how long it takes your muscles to fatigue.

Materials Stopwatch *Participant *Sturdy Wall to Stand Against *You must provide

Procedure

1. To begin, find a wall that is strong enough for you to push against. A temporary wall (such as a partition panel) is not suitable.

2. Find the stopwatch and adjust the settings so it is ready to operate.

3. Stand with your back pressed up against the wall, and lower yourself into a “wall-sit”. To do this:

a. Align the backs of your heels, hips, and shoulders with the wall.

b. Keeping your back pressed against the wall, take a few small steps forward (your upper half will lower as you walk your feet out).

c. Lower yourself into a sitting position, keeping your back flat against the wall, until your knees form a 90 degree angle.

d. Steady this position by focusing the majority of your weight in your heels. Do not allow your lower back to pull away from the wall.

4. Start the stopwatch and time how long you are able to hold the wall-sit position. The amount of time will vary, but will likely fall within approximately 30 – 120 seconds. When you are tired, check the time on the stopwatch, and move out of the position by slowly lowering your body down to the floor or standing up.

5. Record how long you were able to hold the wall-sit in Table 3.

6. Allow your muscles to rest for approximately two minutes, reset the stopwatch, and repeat Steps 3 – 5.

7. Again, allow your muscles to rest for approximately two minutes, reset the stopwatch, and repeat Steps 3 – 5. You should have three trials of data.

Table 3: Muscle Fatigue Data
Trial Time (seconds)
Trial 1
Trial 2
Trial 3

Post-Lab Questions

1. What happened to the time intervals between Trial 1 and Trial 3? What caused this change?

2. Identify three muscles which were engaged during the wall-sit.

3. Explain the biochemical reasoning behind muscle fatigue.

Get 20% Discount on This Paper
Pages (550 words)
Approximate price: -

Try it now!

Get 20% Discount on This Paper

We'll send you the first draft for approval by at
Total price:
$0.00

How it works?

Follow these simple steps to get your paper done

Place your order

Fill in the order form and provide all details of your assignment.

Proceed with the payment

Choose the payment system that suits you most.

Receive the final file

Once your paper is ready, we will email it to you.

Our Services

Ace Writing Center has stood as the world’s leading custom essay writing services providers. Once you enter all the details in the order form under the place order button, the rest is up to us.

Essays

Essay Writing Services

At Ace Writing Center, Nowadays, students normally have extremely busy schedules. You will note that some of them have to take on some evening or weekend jobs in order to get some income that can help them to sustain in college or in the university. This can deny them a chance to write all the essays given. Others usually get bombarded with a lot of work by their lecturers. This can still delay such students from working on all their essays. However, some of them usually try to work on all these essays but end up delivering their work late. This can prevent them from graduating since most lecturers are strict on deadlines. If you want to write a business essay, the wise way is to hire an outstanding essay writing service like us, so that you can get the best results. If you are keen, you will note that many companies usually overcharge their customers. Some of them are there only to make money. And in reality, they really don’t care to build a long term commitment with students. You should not choose such companies. You should take your time and choose a reliable company to work with. Ace Writing Center is the ultimate solution for you. We have been offering our writing service for more than 7 years. This is a clear indication that you will get quality essay writing service. We have a wide range of writers who can work on any business essay that you might have. We believe in doing extensive research so that we can provide quality work to all our clients. .

Admissions

Admission and Business Papers

Have you ever had to write an admission essay for college? The majority of students face the same issues when applying to a university or college and many in such situations decide they need professional help to cope with this matter. They get in a situation when the deadline keeps coming closer but lack motivation to start because they are just not sure if their writing skills are strong enough. We have a solution for you! Ace Writing Center is the best admission essay writing service with a large professional team and years of experience in providing high-quality papers to students of all levels and faculties. The mission of our team is to help students make their dreams of entering a good college come true and that’s what we offer!.

Editing

Editing and Proofreading

Sometimes all the words for your paper just flow out of your mind and into your fingers. You type quickly at your keyboard and there they are, your beautiful words right there on the screen. But you have no idea how to polish it up. You may be wishing there was a paper writing service that offered this type of writing service. Look no more! Here at Ace Writing Center, we offer you an editing and proofreading option that you can't find anywhere else..

Coursework

College Essay Writing

In case you are familiar Ace Writing Center, you know the way to distinguish a better company from a cheap one exactly. First of all, poor service website does not have a sufficient support. We think support team is an essential part of success; it has to answer all clients’ questions and be a connecting link between clients and their writers. On our web-service you will get answers about anything you need and your writer will receive all your instructions, assignments and requirements exactly and swiftly. A writing service that we run has got a flexible pricing system that will save you from senseless wastes and many bonus systems that let you sparing money for something important for you.